Hollowing the axle was the stressful part, the bit wandering was a real threat. I drilled to the center, over 2", flipped it and met the hole on the other side and they lined up perfectly.
4/16/11
Hub Conversion
The bolt on wheels on the Masi had to go. It's silly to need a 15mm wrench, which is uncommon on modern multi-tools, just change a flat...
Hollowing the axle was the stressful part, the bit wandering was a real threat. I drilled to the center, over 2", flipped it and met the hole on the other side and they lined up perfectly.
Hollowing the axle was the stressful part, the bit wandering was a real threat. I drilled to the center, over 2", flipped it and met the hole on the other side and they lined up perfectly.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment